Open API to programmatically create Feature Definitions and Feature Symbologies.
It would be extremely helpful, if we were able to programmatically create Feature Definitions and Feature Symbologies so that automation of the creation of new 'Custom Drainage Features' every time a drainage structure had a different bottom box (...
Allow the road slope to exceed the gutter cross slope
My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...
Enhancement to Create Project Node to Element Tool
There is currently not a way to project a node from the Drainage and Utility Model to an element (horizontal alignment’s profile model). Profile runs can be created and then projected onto the profile model by conduit linkage. With this enhancemen...
Display transparent catchment boundary at the cursor when relocating an inlet.
Enable the user when relocating a catch basin to view the catchment boundary as the inlet location is adjusted. Thus, acting as a dynamic and transparent view of the catchment boundary for the inlet at the new location. This will simplify the work...
Allow drainage nodes to show up as a cell (catch basin, headwall, end section) in profile view.
Drainage nodes show up in 2D as the cell/feature definition it is designated like an end section. It would be useful if that same feature would show up in the profile view for drainage profiles. It currently works for the "utilities" part of "Drai...
Use Tabs to Separate Items for Each Design Element in ORD Drainage
It is cumbersome to have to scroll through several pages of information to design and review drainage elements. KYTC would like to see tabs used, similar to those used in InRoads S & S. Each element (storm sewers, strom sewer inlets, drainage ...
It would be nice to extract Land Use Data from a reference file rather than requiring the Land Use Areas always be drawn in the main drainage design file. This would both cut down on clutter in the design file and also allow larger areas to be del...
Currently when profiling a Utility (nodes and conduits), the lines on the nodes and conduits are "closed". Old Inroads Storm/Sanitary had open connections. Agency we submit the plans want us to show that connection as open. Only option at the mome...
It would be super helpful if I didn't have to search two different property menus for where to change specific properties. If the general properties menu and the ORD DU properties menu could be more centralized into one properties menu, this would...