Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

All ideas

Showing 1143 of 1143

Graphical Results for Cross-Frames/Diaphragms

In the LEAP Bridge Steel analysis dialog box can there be an axial force diagram, with the cross-frames/diaphragms visible?
3 days ago in User Interface 0 Needs review

Export Civil Report to csv

We're using ORD version 2023, and the Civil Reports browser allows us the option to export to xml, html, doc, and xlsx file formats. We used to have a function that allowed us to save as a txt file, which we could change the extension to csv so it...
3 days ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports 0 Future consideration

Need the ability to define sequence number other than at the end of the filename

We have a standard naming convention that uses sequence numbers which are in the middle of the filenames. This has been our standard for over twenty years. Additionally, we require each sheet to be in a separate file for multiple flexibility and a...
3 days ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Pile Embed Length Manual Override

A standard Pier type used in our state typically calls out two lengths of pile ('Long' and Short') that alternate along the width of the Substructure. An example plan is attached. If the ' Embed Length ' variable had a manual override option to ch...
3 days ago in OpenBridge Modeler 0 Future consideration

Allow entering a degree of curve (d 00^00'00") as the Radius of the Alignment Table Editor.

When creating curves, an ORD user is allowed to enter a degree of curve (d 00^00'00") as the Radius. Put the same functionality in the Alignment Table Editor.
4 days ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Display Civil Accudraw Controls on Geometry created using Offset Tools

When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...
4 days ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration

Coincident Sheets with Drawing Boundary

Please add the option to automatically assign coordinate systems to drawing and sheet models based on the design models and to place the sheets coincidently even when they contain drawing boundaries. Right now, we cannot create georeferenced pdfs ...
5 days ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Will not implement

Add Equilibrium Constant to Design File Settings

We need better access and configuration for this constant. There is no place to set this constant.
6 days ago in CANT / OpenRail Designer 0 Future consideration

Clipping reference

It will be helpful to see where the clipping is coming from. Example if reference file then would be helpful to know what reference file
7 days ago in OpenRail Designer / OpenRoads Designer / User Interface 0 Future consideration

Add ability for Overlay/Stripping Top to follow the lowest between component and terrain.

We often need to provide volumes of additional excavation for substandard subgrade material to a certain depth. The easiest way to get this is through the Milling and Stripping functionality. You set the bottom of the component thickness and have ...
7 days ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration