Need Support? Let’s guide you to the right answer or agent.

OpenRail Ideas Portal

ADD A NEW IDEA

Drainage and Utilities

Showing 16

Trim with Connection Points/Regions on opposite sides of cell

I would like to have the ability to put connection regions and connection points on opposite ends of cells, specifically aprons. Currently, the apron won't trim with this setup.
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Oklahoma Time of Concentration Formula

Currently ORD does not have an option to calculate Time of Concentration for the channel flow that the state of Oklahoma uses. This eliminates the option to use the programmed Tc calculator for channel flow. I need an option to put in my own formu...
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 6 Planned

Civil Expression Support for Links / Nodes

Add support for attaching station /offset for Links and Nodes "Set Out" points on. Currently Nodes only report the origin of the cell - which there is a bug in 10.11 version, but we need to also get the center point for eccentric structures. Start...
almost 2 years ago in Drainage and Utilities 2 Planned

Update Extract from Graphic Order of Settings

In the Extract from Graphic tool, the conduit feature definition needs to be set prior to the node feature definition to pull the appropriate corresponding nodes from the workspace. Could the conduit feature definition settings be listed above the...
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Add shear stress calculation (based on HEC-15) to conduit data.

Conduit data has flow data but not shear force data which would help design the channel lining needed to protect from ditch/channel erosion. https://www.fhwa.dot.gov/engineering/hydraulics/pubs/05114/05114.pdf
about 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Automate Node labelling in Cross Section drawings

We need to be able to label nodes in cross sections drawings automatically. At the moment, this can only be done one node at a time, unlike conduits, which can be labeled automatically.
about 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned