When using the “New Point” command for a survey point, the user must screen-pick the coordinates. There are times when it would be extremely useful to hand-enter the Northing, Easting, Elevation.

Currently Survey Media files can only be viewed in the dgn file with the fieldbook. Can we get an enhancement to view photos when the survey fieldbook file is referenced to another file.

When working in a fieldbook in survey, we want to set the default file path to a specific location for .tiw files. As it stands, ORD remembers the last location from which a .tiw was imported, but we want to set a file path for all users.

Survey chains (when enclosed) have a reported area value of zero. This is seen in the properties for the geometry, and also if you try to read the area through an item type using the expression This.GetElement().EnclosedArea. Our construction staf...

Add the ability to take surface templates into account when analyzing volumes between two terrain models. That way you will not have to create a delta terrain, for instance when you want to take the clearance of top soil into account. This option ...

At present, the Deed Writer tool describes boundaries only. We should be allowed to use this tool to also describe easements and acquisitions. For example: If an easement is necessary to be described along the centerline of a sewer pipe.

Need the ability to add a predefined template to control codes. For example, I can create curb and gutter templates that would generate the needed linears at the correct horizontal and vertical values.

The ability to use an offset to create a single line alignment based on a regression line that was created by points. This ability would allow the user to create a centerline alignment based on monuments/survey points located a specified distance ...

This will be useful because it will allow us to create a legend cell of the TIN files like in GEOPAK. https://www.youtube.com/watch?v=BFVsRRx-4qY

Geometry/Lines requires you to enter the bearing value as S45d30'30"E which is way too many key strokes and unproductive. Geometry Builder allows us to enter the same bearing using the quadrant method (245.3030) which is much faster/easier and ali...