As a Highway Engineer, I want the horizontal alignment reports to show deflections at PIs even if there is no curve, at least one of the reports so that I don't need to add it manually.

Alerts users to the existence of "kinks" in horizontal alignments. These "kinks" are where the back and ahead tangents at PCs and PTs of curves are not on the same bearing. There is a small tolerance built in to eliminate rounding errors.

Something very useful in MicroStation and AutoCAD is the ability to define an arc by 3 tangent points. The elements could be of any type and each point would belong to a different element.

A tool to reverse the direction of an existing complex element. There is a workaround by complexing the complex element but not an ideal solution.

There should be tools to allow the end elements in a complex element to be replaced by the designer. The Redefine tool can be fine for elements in the middle and the append tool may be fine for just adding but if I want, for example, to swap the l...

When creating vertical curves "from element" it would be really useful to be able to set the outgoing slope (I have not been successful using "civil accudraw" for this purpose...).

Within the Table Editor tool, provide the designer the ability to graphically edit the profile while simultaneously locking any particular VPI or grade in proximity to where they wish to make a change. This was an awesome feature in Vertical Geome...

Requirement is to annotate horizontal length of straight on profile (station end - station start). It is available in frame annotation but not along linear so annotations don't match. Only the slope length can be annotated along the linear

This would literally save large projects 100s of hours. Plus having points in tables that are ruled eliminates so many chances for errors. Other civil products have had this feature for years. Creating grading points on plans is so easy when table...

To have to go to the Back Stage and select Settings ==> File ==> Design File Settings ==> Civil Formatting ==> Degree of Curve Method to change from an Arc Defined Curve to Chord Defined Curve is not a good workflow. In our State we ca...