Need Support? Let’s guide you to the right answer or agent.

OpenRail Ideas Portal

ADD A NEW IDEA

Geometry

Showing 152 of 1283

Manual Editing of Cant: Make it easier and allow it to be permanent.

The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
10 months ago in CANT / Geometry / OpenRail Designer 0 Future consideration

Add Create 3d Automatically Options

The Create 3d Automatically in the Feature Definition toolbar has the potential to be really powerful. Add the ability to have other options. The one I would most like to see is "Profile from Surface" based on vertices, locked to start and end.
10 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Add "Auto Activate Profile" to Feature Definition Bar

Add a toggle to activate the next profile that is drawn rather than having to manually activate most profile lines.
10 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Make profile active without opening profile view

It would be useful if some of the profile tools (quick profile from surface, profile from surface, etc) had a toggle to allow the profile to be set as active when it is created. This would make it more efficient in cases like when you need to crea...
10 months ago in Geometry 1 Future consideration

Display A parameter (not Length) after using "Create Civil Rule Feature" option.

When I create an alignment with curves using A parameter and when I select this alignment "A parameter" will be properly displayed. Then when I "Remove Rule" and use "Create Civil Rule Feature" tool, A parameter will be replaced with "Length".
10 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Reverse complex geometry into elements

currently creating complex geometry is irreversible and extremely difficult to edit. neither on-screen nor table edit work well to modify complex geometry, especially removal of PI with curve sets. Also, delete element from complex is not unattain...
11 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Snap to specific chainage in Plan

In PRT it was possible to snap a smart line to a specific chainage in plan by using the key-in 'SO=xxx'. In OpenRail the closest tool I can find is Civil Accudraw with station-offset toggled on, but I have found that often CivilAccudraw does not w...
11 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Accudraw Integration with Civil Geometry Tools

Enable the ability to utilize Accudraw with the Civil Geometry tools [lock perpendicular to drawing compass]. Currently I do not know a way to draw perpendicular lines using the horizontal and vertical civil geometry tools unless I manually type i...
11 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Join Function in Table Editor Function similar to in Bentley Rail Track Horizontal Check Integrity Box

The join function is not available to join two or more straights with the same bearing that falls under one 'Complex Geometry'. This is especially problematic currently for us as there is currently no way to join two straights (see 'ORD Join Funct...
11 months ago in Geometry / OpenRail Designer 1 Future consideration

Ability to View Alignment Stationing in Plan View in ConceptStation

I am requesting an enhancement to allow the user to view alignment stationing in plan view in ConceptStation. Currently, alignment stationing can only be viewed from the profile model. This would be helpful when adding PI points or modifying horiz...
11 months ago in Geometry / OpenRoads ConceptStation 0 Future consideration