OBM is limited in the cap shapes it can accommodate currently. It would be very helpful if we had the ability to draw cap shapes in the front elevation view and use those as templates, which OBM extrudes in the up/downstation direction. We would l...

When creating a profile Named Boundary, there is no option to set a starting or stopping elevation, or an elevation range. It's a bit of a black box how that is determined by the software, and we need more control. It's entirely possible to create...

In the ‘Code Checker Results’, the program summarizes for each girder all the critical load combinations, AASHTO code and controlling performance ratio. As in some diaphragm locations, the program is stating the girder is controlled by fatigue and...

I agree that the excess reinforcement factors would be different for each POI and load case. That is one reason most engineers conservatively ignore that factor. A simple or temporary solution is to set that factor equal to 1. I believe that AASHT...

From the user: "I have a straight steel bridge no skew and it is classifying cross-frames as primary members. Is there away to set cross-frames as secondary member for kL/r check?" This happens because All elements are only set as primary, without...

Cross Section to Surface-This needs added back in the program. Using a 2D interface to make a ditch with ORD (the most simplest part of the roadway) has gotten so complicated and beyond time consuming. I would estimate xsecs now take at least 10 t...

Why is this so slow and have to hit "o" to target what you want to track? We only care about the horizontal alignment and everything is built off that. That tool never works and it is just a constant fight. You will key say Sta. 500+00 and want le...

Incluir as normas de ações em pontes no cálculo de linhas de influência em WIZARD: NBR 17245/2025 - Ações em Pontes FerroviáriasNBR 7188/2024 - Ações devido ao tráfego de veículos rodoviários e de pedestres em pontes, viadutos e passarelas

Incluir no lançamento wizard a opção de considerar cabos curvos e dimensionamento com pós-tração nos cabos. ENGLISH TRANSLATION: Include in the launch wizard the option to consider curved cables and post-tensioning of the cables.

Incluir e Melhorar a análise FEM. Adicionar a possibilidade de modelagem de lajes em FEM no wizard, com o objetivo de agilizar o fluxo de trabalho.