The parametric model, Generative Components, does not allow transfer of elements to analytical models such as RM Bridge and LEAP. Please update functionality so this is possible.

Currently, the View Independent option for Civil Labeler is not available for labels with leaders. Expanding this option to include labels with leaders would be highly beneficial. It would allow labels to be placed in the Default model for the ent...

In Geopak, we had the ability to take individual alignments and create an overall alignment from a subset of alignments and it would hold the individual stationing for each alignment, creating station equations. There is no way to do this in ORD u...

Interface Currently, writing expressions in expression builder is only slightly better than writing code in notepad. The interface could be enhanced similar to Visual Studio with colorized classes, methods, and properties, colorized brackets with ...

I would be helpful in many chases to be able to set Huanch to be above Top Flange of Steel Beam, or even to set it in any place of Beams Hight.

For now, the annotation of High and Low Points is very limited:# only one Low Point is detected - multiple low points are ignored# its is a linear3D annotation, and snaps on the annotations are not ruled (this intent is to be able to place drainag...

In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows: ...

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

The OBM-OBD BIM workflow may work fine for standard style bridges, but when odd geometry is encountered, it would be helpful to be able to make modifications within the LEAP Concrete OBD file for analytical reasons, without affecting OBM geometry,...

We need the software to have capability in reporting to interpolate lift and slew values between regression points. Because currently when a complex alignment end point is between regression points the reporting only picks up the lift and slew val...