Need Support? Let’s guide you to the right answer or agent.

OpenRail Ideas Portal

ADD A NEW IDEA

My ideas

Showing 139

WS wind speeds table for FDOT Sdg 2.4 (and combinations) are not updated as per 2025

There appears to be a discrepancy in wind load calculations—specifically, the gust factor of 0.85 remains different from AASHTO standards. However, the FDOT Structures Design Guidelines (SDG) 2025 now allow the use of AASHTO Article 3.8, which may...
2 months ago in OpenBridge Designer 0 Needs review

Drainage Annotation rotation based on sheet view rotation

Currently, the only rotation options for drainage annotation is constant. With alignments that are curving, our sheets must change rotation. It would save a lot of time spent manually adjusting rotation on each sheet.
6 months ago in Annotation / Drainage and Utilities / OpenRail Designer / OpenRoads Designer 2 Needs review

Civil view Settings (Drainage and utilities) in Personal Preference

Have the Civil preference for drainage and utilities as file setting rather than personal preference. There are times we had to change the settings depends on what we are designing. eg. we want to show connecting conduit if we do drainage, not whe...
7 months ago in Drainage and Utilities 0 Needs review

Enhancement::Additional Tool for Design of Cross over connection between Tangent & Canted Tracks

I suggest improvements to Bentley OpenRail Designer for handling Cross over connections in the following scenarios: Cross over Between Adjacent Tangent Tracks: Enable a simple geometric connection between two parallel tracks without the use of Geo...
10 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

Separate Limiting Tension Stress at the Top of Prestressed Concrete Girders Near Interior Supports

Add a separate limiting tension stress for the top of girders near interior supports. AASHTO LRFD permits the use of a limiting tension stress at the top of girders near interior supports for Service III different than the limiting tension stress ...
about 1 month ago in OpenBridge Designer 0 Needs review

Remove length restriction in offset geometry command

Please remove the restriction that makes it impossible to make the offsetted element longer than the base element. It is normally the direction that is important and the length can be edited afterwards. Otherwise add an opportunity to remove the r...
3 months ago in Geometry / OpenRail Designer 0 Needs review

Unable to report on Geometric Points direction relative to an Alignment.

In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...
over 1 year ago in OpenRail Designer 2 Needs review

Delete Point functionality in Regression Points Table

A functionality in the Regression Points Table, particularly for deleting the points are missing in this table. The current workaround is to navigate through Explorer and delete the regression points, one by one, which is an issue if you have many...
about 1 month ago in OpenRail Designer / Regression Analysis 0 Needs review

Request for Sideslope End Condition Targets Between Multiple Roadway Alignments in ConceptStation

This product idea proposes an enhancement to ConceptStation that would allow the sideslope end conditions on multiple roadway alignments to target each other to prevent overlapping slopes. Currently, this is only possible with the intersection, ro...
about 1 year ago in OpenRoads ConceptStation 0 Needs review

Point Code and number included in the regression points

The point code and number should be included in the regression points so that it can be printed out and identified when you make a regression report. If you only see the stationing and offset from the geometry you cannot separate normal track poin...
9 months ago in OpenRail Designer / Regression Analysis 0 Needs review