Ability to insert a series of event points, e.g., every 25 m along axis, in a single shot at once

Please return the export to DWG/DWF functionality available in previous versions. Not every customer uses Microstation DGN files.

In the Cant Editor, there is a tool called validate data which allows you to add in your design parameters and then check against the cant the Openrail has already automatically generated. although a good tool, i just think it would be better Open...

ADD ANOTHER BUTTON TO TURN ALL DECORATIONS OFF AT ONE TIME

With Inroads Survey, whenever XYZ coordinates needed to be entered for a particular purpose, a screen-pick option was always available. (see attached image) This was extremely useful. However, with ORD, changing the XYZ coordinate of any points in...

For large scale projects, earthwork volumetric meshes cause considerable deficits in navigation performance due to the high count of vertices and faces to be calculated with each navigational operation. Use of scalable meshes for these components ...

When designing drilled shafts, there is no option to display controlling shear and moment loads (bottom of column). This is needed for the geotechnical engineer on designing th drilled shaft. For column design, it is sometime useful to also show c...

It could be useful for different purposes to be able to create component meshes of defined length (construction, pre cast slab). I suggest to add at least 3 parameters to any component: length of the component: the question is then, where to measu...

Current default setting shows Vertical Curve Parameter or K-Value below the parabola length in the dynamic display of a vertical alignment. The geometry report has to be run or the annotation must be displayed to see the available SSD. It would be...

In placing drainage node to the carriageway or kerb/curb lines in 2D plan, it is useful to show the flow arrow from high point to low point for the drainage engineer. Currently, the flow arrow is only available in "Terrain", but not civil geometry...