Ability to define the slope of any points within the dynamic section using the measure tools
Having the ability to quickly check both existing and design crossfall/superelevation would increase efficiency within the program as there would be no requirement to run a template and report to evaluate existing cross slopes
Would like to be able to use the dynamic tools to see the slopes/distances on the non-active corridors that are in the dynamic view as well. the points should exist already, they just aren't active in the file
I also use to love the dynamic reports in MX. You could flick through the properties from each of the reference element's points to the perpendicular intersecting point of the second element e.g. distance, slope etc. Very useful for checking.
Realistically the current behaviour is a defect - you should be able to measure between any 2 points in a dynamic section view using the section measurement tools, but currently only works on corridor points of a specific corridor if it was used to open the section
Would like to be able to use the dynamic tools to see the slopes/distances on the non-active corridors that are in the dynamic view as well. the points should exist already, they just aren't active in the file
I also use to love the dynamic reports in MX. You could flick through the properties from each of the reference element's points to the perpendicular intersecting point of the second element e.g. distance, slope etc. Very useful for checking.
Realistically the current behaviour is a defect - you should be able to measure between any 2 points in a dynamic section view using the section measurement tools, but currently only works on corridor points of a specific corridor if it was used to open the section