Create a rule to set drainage node to (active terrain) when setting elevation reference
Presently when setting reference elevation for the node it lets you set it to the active terrain but does not rule it to the (active terrain). If this were done the inlet tops would automatically adjust as the design terrain changes.
DU: add drop calculation to node invert depending on lowest conduit wall thickness
Some times, most common with concrete conduits, the node invert needs to have a drop in reference to the lowest pipe to acomodate its wall. This would later be filled to match.For construction and BIM purpose, this difference is important. Special...
Separate 3D line and 3D object for pipes to different levels.
In Drainage & Utilities, the 3D line and the 3D object for a pipes(conduit/link) is placed on same level. It would be great to have them on different levels - also because it can be a demand from from clients in Denmark, that the line is place...
Circular Eccentric MH Feature Definitions Rotation Reference Point Addition
The insertion point for circular eccentric manhole feature definitions is at the center of the MH 2D top. When it's rotated, it rotates at that point instead of the center of the 3D base. Please create the ability to use the insertion point to set...
Flow Arrow from High to Low Point for any Civil/Linear Geometry
In placing drainage node to the carriageway or kerb/curb lines in 2D plan, it is useful to show the flow arrow from high point to low point for the drainage engineer. Currently, the flow arrow is only available in "Terrain", but not civil geometry...
in Drainage and Utilities, remove the Maximum Spread (global for the dgn file) and make it editable for each individual node. Roadways have lots of different gutters etc so I don't want a max spread for the whole file, I want individually.
Allow multiple drainage node elevations to be simultaneously assigned to a terrain
It would be helpful if multiple drainage nodes could be assigned to a terrain in one step. This would solve a problem if someone deletes the proposed terrain that was used to initially layout the drainage system. Currently users have to update the...
Add columns for conduit construction length and constuction slope to flex table
Is there a way to add constructed length and constructed slope to a conduit flex table? I can build annotation for these fields for plan production, but I haven't found these fields to add to a conduit flex table. This would allow for more options...
Allow spread sections to be read directly from a terrain model or Corridor Model
Geopak Drainage could read a TIN file to establish the cross slopes for spread. This functionality should still existing in Drainage and Utilities by reading corridor models and terrain models. Users should be allowed to define an infinite number ...