I would like the ability to control the limits of the profile run in profile sheets which would also allow me to control the stationing without having to create a separate alignment and project the drainage run into the separate alignment.

This would dramatically reduce the requirement for a vast number of library cells and feature definitions to be created

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

Ohio DOT likes to see the spread and depth at the edge of the grate. Currently the software reports on the spread and depth at the start and end of the gutter. Would like additional properties to also report the spread and depth at the edge of the...

It would be nice to be able to export a drainage network into 2D linework that can be edited for plan sheets. Currently, we don't use our modeled files directly in our plan sheets as we cannot adjust the conduit line styles and it takes longer to ...

Pressure pipes are essential components of many engineering systems, such as water supply, oil and gas transportation, and power generation. To design and manage these systems, engineers need features that can model the geometry and properties of ...

There is currently not a way to project a node from the Drainage and Utility Model to an element (horizontal alignment’s profile model). Profile runs can be created and then projected onto the profile model by conduit linkage. With this enhancemen...

It would be very helpful and much more efficient if there was an option to insert a vertical bend or curve into a drainage link/pipe from the profile run profile view. Basically, adding the exact same tool that is available in plan/horizontal call...

Enable the user when relocating a catch basin to view the catchment boundary as the inlet location is adjusted. Thus, acting as a dynamic and transparent view of the catchment boundary for the inlet at the new location. This will simplify the work...

When Switching between state of a Structure Existing and Proposed, Removed, Etc. we need a way to keep the same Feature we should be able to Either Map to a property to choose the Level to Display or be able to overwrite the Level Via Display Style.