Make it easier to manage longitudinal spread slope. It's nice to input the slope in the properties per node, but consider making it integrated to the gutters used during bypass flow drawing of gutters.

It would be helpful to manually create a point (say via imputing a station and elevation) that is similar to the profile intersection point tool. For example, I want to be above or below a certain point where I am testing a variety vertical curve ...

Currently the lengths given by the Table editor gives Chord defined curves as Arc defined lengths. So the length and the stationing are off.

A command where, once activated, would prompt the user to select the first point, then the second point, and then the user's cursor would snap to a location located exactly in between the two points. This could be done without drawing any unnecess...

Drainage nodes currently utilize an Elevation Reference and a Baseline Reference. It would be better to split the Baseline Reference into two separate references, 1) "Station Reference", and 2) "Offset Reference". In practice, this would allow a n...

It would be nice if we could input a text file that contains all geometry information into the program and it would be created automatically

When zooming out, the points are shown. When zooming in, the points are hidden and the text is shown. I'd like for the point to always be shown and have the text be dynamic.

We have several sheets where we want certain lines that have specific feature definitions to have a dimension on the plans. We also have several shapes that we always want to show hatching or patterns appearing on the plans. Right now we have to m...

It would be great if we could create a field (text favorite) that would label the station begin and end of a named boundary for an index of sheets layout.

Ability to flip/reverse cross sections around baseline. Currently, when you reverse section, it does not hold station 0.