Reinforcement is typically tied together and is 3D modeled to reflect that. For example, a U bar tied into longitudinal/vertical bars. When a section cut is taken, the drawing models appears to show a single long U bar and not 2/3 separate bars. B...

Our bridges are designed with a haunched (or angled) soffit at the outside edges of the deck. These extend from the outside edge of the deck down to the top of the outside girder flange. Right now, this can be fudged in a deck template on a straig...

Currently, the only way to place a single point slope label on a terrain is using the "Analyze Point" tool which works ok, but there are no options at all for controlling the display of the label placed. We would like to have the ability to place ...

OBM does not currently allow for bent connection plates for diaphragms / cross frames. We need that ability to cover bridges skewed between 20 and 45 degrees.

Multiple options should be available (node handles that can be manipulated, a match slope to conduit option in properties, a degree value that can be keyed-in, etc). This should allow for simplified placement of cell nodes that serve as pipe fitti...

I will use ORD as an example. I, along with many others, have chosen to remain on ORD 10.12 due to a constant string of issues with more current releases. Most recently, I tried to upgrade a project from 10.12 to 24. This resulted in my Text File ...

When exporting a report to an Excel file, the .xlsx is saved as a shared workbook. This functionality can cause OneDrive saving errors, as well as limited capability when using the workbook itself. This request is to turn that setting off in the E...

For now, the annotation of High and Low Points is very limited:# only one Low Point is detected - multiple low points are ignored# its is a linear3D annotation, and snaps on the annotations are not ruled (this intent is to be able to place drainag...

Trench templates are used on pipes for fill quantities. It would be useful if you could place a trench that would automatically assign parametric constraints based on the size and pipe thickness of the pipes. Also, shapes other than a circle are d...

Having the ability to quickly check both existing and design crossfall/superelevation would increase efficiency within the program as there would be no requirement to run a template and report to evaluate existing cross slopes