When I use the civil analysis tool, I sometimes place the displayed graphics (elevation, contour, triangle) into the drawing to have a record. The problem is when I am done with the graphic and want to remove them, I have to select each component ...

Being able to change the superstructure type after the deck, substructures, approaches have already been modeled. Currently once you select the Bridge Type it locks you into that superstructure type and any work you complete under that bridge type...

User is wants the terrian report from native Geopak which gives Root Mean Square Error to be added to ORD. In Geopak there was a tool "compare point to tin" tool that provided a report. This report would provide the "Root Mean Square Error". In OR...

Please update Migration tools to support the new features in OpneRail Designer. This to support Bulk editing for "the new Low Voltage" Feature settings to add our own library.

We would like to ask a PMM non-linear spring for modeling Plastic Hinges for reinforced-concrete Columns. This PMM springs are used for modeling the Moment-Rotation (M-R) behavior for different axial loads (P). The PMM spring should be able to cap...

Users who can't access the Software Downloads page cannot see the combined version/release numbers of available software packages. They can only see the release numbers on the product documentation pages, but cannot see the associated version numb...

When creating cut and fill meshes in ORD it creates the meshes for the entire design file. This applies a feature definition for both the cut and fill meshes that only allow for one applied shrink/swell rate. It would be helpful to be able to appl...

Is there a way to dynamically adjust the limits of the labeling tools? The issue we're running into is that parallel facilities show annotation that seems skewed and might be interpreted as misleading. We understand that we can set up a set offset...

I am asking for an enhancement for XSECTION ROAD name to be added for Cross Section Annotation purposes. I want to add the name of the alignment that the sections were cut from to each section even if it does not have an active profile to be secti...

I want to be able to annotate the names (and item type properties) of utilities on cross sections and profiles. For example, if there are 10 water pipes that have been surveyed and imported as 3D linear elements they will have unique feature names...