Ability to annotate superelevation transition locations (NC, LT, LR, FS, etc.) points with slope direction indicators in plan view.

In legacy versions of the software, I can have the template library open on one screen, corridor modeler on another screen, and the CAD window open on a third screen. I can make/save changes in the template, make/save changes in the corridor model...

In recent versions of OBM, the ability to add or remove SupportLines was added. While this is helpful in some cases, it would be more helpful to have the ability to change which SupportLines a given Deck or Beam Layout belong to. That way if the S...

It would be nice to have the ability to reattach civil labels to a new element or terrain. A good example is for jointing/geometric sheets with a lot of spot elevations. Fairly often a new terrain is created and the spots break and need to be repl...

Show and annotate projected points on profile view. This is for dynamic and drawing production profiles.

I need to place a Pier Diaphragm that does not encompass the beams inside the concrete diaphragm. TDOT requires 18" between the beam ends at the piers. The Diaphragm is placed between the beam ends and then skewed between the beams transversely, ...

When creating named boundaries of any time, a saved view is created for each named boundary. The creation of a saved view is a method that is supposed to control the look and feel of the drawing/sheet, but it is over-complicated, poorly understood...

Our bridges are designed with a haunched (or angled) soffit at the outside edges of the deck. These extend from the outside edge of the deck down to the top of the outside girder flange. Right now, this can be fudged in a deck template on a straig...

Reinforcement is typically tied together and is 3D modeled to reflect that. For example, a U bar tied into longitudinal/vertical bars. When a section cut is taken, the drawing models appears to show a single long U bar and not 2/3 separate bars. B...

Civil labeler only works for 3D linear features (points). It`s impossible to annotate the slope from the terrain between two points. If you try that, the whole terrain section is selected and the command fails. A great example is a cross section o...