Need Support? Let’s guide you to the right answer or agent.

OpenRail Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1390 of 1390

Update the Check Integrity Reports to include both the Start and END stations of the elements.

The current report has the Start station, but it would be nice to have the Ending station of the individual elements included as well.
7 months ago in OpenRail Designer / OpenRoads Designer / Reports 0 Future consideration

Ablity to connect two nodes directly by flange

For the water supply project, in a situation where we have cast iron elements connected to the flange such as gate valves, hydrants, elbows, venturiers and plastic line pipes. There is no way to connect the two nodes directly through the flange. a...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add Offset Format options to the Baseline Offset Text Favorite

Add the Offset Format options that are available for the Point Offset text favorite (Positive Prefix, Negative Prefix, Positive Suffix, Negative Suffix, and Show Sign) to the Drainage Baseline Offset text favorite.
about 1 year ago in Annotation / Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

Add Dimension Tool

There needs to be a Dimension Tool for adding/seeing dimensions that are not already present on the outside dimensions. Example - Standard Highway Sign Guide (2012) - D2-2 - Spacing for L currently cannot be shown in the program.
about 1 year ago in OpenRoads SignCAD 0 Future consideration

GenerativeComponents - Feature Definition tool Node

Special Node/Option for Full recognition (reading civil information) and creation of Feature Definitions in GenerativeComponents. GC & Civil Packages would benefit greatly if we could automate the creation of Civil Lines (2D/3D) for subsequen...
about 1 year ago in Modeling / OpenBridge Modeler / OpenRail Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Allow cut and fill meshes to be created by named boundary

When creating cut and fill meshes in ORD it creates the meshes for the entire design file. This applies a feature definition for both the cut and fill meshes that only allow for one applied shrink/swell rate. It would be helpful to be able to appl...
almost 2 years ago in OpenRoads Designer 0 Future consideration

Replace or swap master survey terrain without losing links or relationships

Replace or swap master survey terrain without losing links or relationships to design elements or other corridors, DGNs etc. I use a complex terrain to achieve this now, it would be nice to have another option
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Non automatic update of cant values in cant table

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...
over 1 year ago in CANT / OpenRail Designer 0 Future consideration

curved corners in bridge geometry

OBM should allow o define sharp corners for decks and barriers (in addition to rounded). Currently every turn is interpolated using spline type of line, without control from user end (regardless of the manipulation for the chord and distance betwe...
almost 2 years ago in Geometry / Modeling / OpenBridge Designer / OpenBridge Modeler 0 Future consideration

RM Bridge Envelopes for Shell Forces

I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.
10 months ago in OpenBridge Designer / OpenBridge Modeler / Reports 0 Needs review