A lot of time our employements ask for dwg XS, profile and plan drawings, I consider very useful a set of settings ti create them without issues.

Please update Migration tools to support the new features in OpneRail Designer. This to support Bulk editing for "the new Low Voltage" Feature settings to add our own library.

For box shaped conduits, we need to be able to define top, bottom and side wall thicknesses independently. This allows modeling of box shapes which correspond to physical construction.

Users who can't access the Software Downloads page cannot see the combined version/release numbers of available software packages. They can only see the release numbers on the product documentation pages, but cannot see the associated version numb...

In most of the DOT standards Cross Section Annotation groups, the labels have begin offsets defined for leader. And sometimes users need to and few labels manually in the cross section sheets using civil labeler or using the Place Label tools. Whi...

It would be nice if we could input a text file that contains all geometry information into the program and it would be created automatically

This is a must have feature for precast bridges.

Adding the ability to assign an offset length for the centerline of bearings within the bridge wizard. The program defaults to 9" from the working line of joint. Alabama uses 1'-0" as a standard at piers/bents and we have a standard range between ...

When creating cut and fill meshes in ORD it creates the meshes for the entire design file. This applies a feature definition for both the cut and fill meshes that only allow for one applied shrink/swell rate. It would be helpful to be able to appl...

This would be useful for agencies with strict installation procedures that prevent the installation of exe files.