Civil cells contain horizontal and vertical geometry. In practice, typically the vertical design is unique for each placement instance of design features that could utilize civil cells, even though the horizontal geometry is similar or varies para...

In the Active Template pane of the Template Library, we are able to see Point Feature Definitions and Component Feature Definitions that have been assigned. However, we are not able to easily see all Points or Components which have no Feature Defi...

We often get plats that have interior angles and distance for the parcels, tracts, etc. It would be nice if this option was in geometry builder.

In profile view, the top of Transition Node is tied with group elevation; and bottom elevation meet the pipe. Any chances to make the only “Transition Node” showing as “point” or “line” only in Profile? J ust only one point in the invert? Setting ...

In the regression points table, there is no way to sort the regression points using stationing. It means that if points are not named so that you can order by the name, it becomes difficult to navigate and understand the table. Regression points b...

The labels for the ST, TS, CS, and SC points are in the lower part of the profile and are in offset with reference to the horizontal geometry band (as seen in the photo below wherein the radial offset is referenced from the geometry band). I think...

We have had several profiles views disappear from our sheets and have had to recut the sheet. Would be nice to be able to manually attach the profile back to the sheet.

TDOT doesn't encase the beams inside of the pier diaphragms. TDOT places an 18" diaphragm between the beam ends with bent-up strands being used for anchorage into the diaphragm. If the bridge is skewed, the diaphragms are skewed at a different ang...

It is often necessary to check the slope in a specific point/section of a vertical curve, but this cannot be done right now with the "Analyze Point" tool. No matter where on the alignment I click the slope that displays is the slope of the first v...

We use a federated workflow where our geometry is in separate files, and each corridor is in a single file. We also use the left-center-right modeling concept where pavement corridors are in separate files from grading/end condition files. In this...