We should be able to import profiles from elements. Because the profile drawing gives us usually like dwg file format, or like cad file format. if we draw an empty profile same dwg's profile scale on the screen, we can import dwg profiles very eas...
Allow LFD substructure analysis with an LRFD Superstructure in LEAP Steel
When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...
Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope
When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...
Contents of terrains currently can't be viewed or edited. Features can be added and removed from a terrain but there is no viewable info on these elements. What elements is the terrain created from? What elements are used for triangulation? Survey...
Add Ability to report both values XY of alignment and XY of the cursor to Analyze Point tool Currently choosing civil analysis by point, x - y val
ue is only given for the alignment to analyze the point but the actual point coordinate at it's loca...
label contours from inroads. there are times we have to label elevated "graphic" lines (aka contours and or benches without having a terrain model). was very helpful in inroads)
Access to full Backstage menus prior to opening a file
There may be times when a user would like to utilitze the Tools, Civil Tools, etc. or change user prefs, configuration variables, etc. Currernty you have to open a file before you can access the Backstage.
almost 2 years ago
in User Interface
0
Future consideration