While modeling complex projects there has been many instances where I would like templates to not connect features between drops. My current workflow is to create a new corridor at these locations. One example is when a new roadway base course sec...

For modeling corners that is harder to do with templates, similar to Civil 3d, the ability to quickly manipulate elevation points and slopes on a 3d wireframe design would make designing curb ramps so much easier.

Currently, when one uses the create regression line from rails tool, the points that the program creates are 2D, in other words they contain only X and Y, not Z. It would be nice to create points along with the regression line that contains also i...

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...

In ORD, In the Template window, would be beneficial to be able to create EC components made up a series of template points and "break" them into separate components and then merge them back together.

OpenRoads should have a Command that place a line between two imported points (.asc, .crv, .txt file) V8i does have a command that will place a line between two imported points. After importing the points into the drawing, you click on the "line c...

OpenRoads uses different types of file open dialogues throughout the program. The first type allows the user to paste a file address directly into the navigation bar. The second type does not allow the user to paste the file address and forces the...

When we initially stood up Storm and Sanitary, we had the center point presentation in plan view display a representative cell. I propose that we allow the placement through an element template of an annotative cell at the center of nodes to repre...

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...

From rail companies in Switzerland we receive their rail alignment in form of an .xtr file. This file includes geometry, station, cant, construction and destruction phase and turnout information. Currently the import of an XTR-file in OpenRoads is...