This would be very similar to the way that OBM creates and manages bents, columns, footings, etc. This would allow for more rapid population of custom vertical sign items in our 3D design environments. By this I mean items of different sizes, span...

In Drainage & Utilities, the 3D line and the 3D object for a pipes(conduit/link) is placed on same level. It would be great to have them on different levels - also because it can be a demand from from clients in Denmark, that the line is place...

Add ability to create speed table based on minimum-maximum cant/cant deficiency and curvature.

We can add points to regression line but we can't remove points from regression line.We can ignore but it is not good management especially if you added a wrong point to the regression line that must be added to another regression line. Because th...

At present, when selecting a feature definition for a profile run, it only affects the construction element created immediately after defining the profile run. It would make sense to have a setting where the feature definition of the profile run o...

Currently in ORD existing cant can only either be viewed graphically in the curvature diagram or from within the cant editor. Current workflows to annotate existing cant in profile require the projection of both left and right rails in the vertica...

As agencies transition from using the survey foot to the international foot, their workspaces in OpenRoads need to be thoroughly reviewed and updated. A critical component of these workspaces is civil cells. However, civil cells do not scale corre...

Catch basins have the following flow types that can be added: additional subsurface flow (cfs), known flow (cfs), additional carryover flow (cfs), external CA (acres), and external Tc (min). Manholes only have the option of known flow. Known flows...

Allow a checkbox to choose to overwrite or replace existing saved views when re-processing a set of named boundaries for output to sheets. This will help to maintain order in the files and avoid excess unused items. If not creating another 'versio...

The class of a pipe is primarily selected by the depth of cover over a pipe. Sometimes vehicle loads or construction loads have an influence on the class selection