We can add points to regression line but we can't remove points from regression line.We can ignore but it is not good management especially if you added a wrong point to the regression line that must be added to another regression line. Because th...

Example would be for Pipe lengths. If a label is set to place the "designed" pipe length, but it needs to be changed to constructed pipe length. And that civil label has been used multiple times in multiple sheets. It would be great if when someon...

Geometry connector for verticals, missing vertical geometry editor is an issue for Ramboll and other similar consultancies in Denmark

If you check the "Do not Show Again" box and press OK to the warning message in OpenRoads SignCAD 2023, then you can add additional panels to the file without the warning message displaying. However, closing and reopening the file will cause the m...

For now ORD Cross sections have limited capabilities compared to MS Clip volumes. Request is that ORD cross sections do inherit full capabilities of MS Clip volumes, including capability to define a thickness for point clouds and project the Point...

It appears that we need to 'nudge' or 'kick' element templates to find correct level and therefore symbology in 2024. It's not auto populating when we select an element template. We have a section line linestyle tied to a level tied to an element ...

Circular eccentric nodes, like manholes, should have the ability to have a rotation point at the center of the structure and elevation reference at the center of the frame and cover.

The XS annotation group will place annotations in text conflicting locations. Once the user resolves the text conflicts there is a chance that the annotations may have to be revised when the model is updated. Therefore, it would be helpful if ther...

It's a little cumbersome to keep going back and forth between models when developing annotation groups. An alternative could be to be able to select the geometry that is shown as the example when in the annotation group manager.

We often need to provide volumes of additional excavation for substandard subgrade material to a certain depth. The easiest way to get this is through the Milling and Stripping functionality. You set the bottom of the component thickness and have ...